Can I replace pressed wheel bearings myself?
Because the bearing is pressed in, even people who have successfully done a lot of repairs themselves hesitate to tackle this job on their own. You have to decide whether to attempt the DIY repair or send it to a shop and pay the extra cost.
Overview
People affected2 accounts across 2 forums
Workarounds found2 items attempted
Community agreement3 total upvotes
What people tried
Every workaround mentioned in the threads below. We haven’t tested any of them — and nobody here is claiming they worked.
2 items+ Contribute
Found another way around this?
Share your steps and trade-offs so fellow engineers don't have to reinvent the wheel. No account required.
- 1Paying a professional mechanic shop to do the replacementDid this help you?
- 2Asking a local shop to press the bearing in for a small feeDid this help you?
In their words
Unedited, grouped by where they were said, most upvoted first within each place, each linked to the thread it came from.
r/AskMechanics1 person · September 2026
r/MechanicAdvice1 person · October 2026
“Purely cosmetic and material loss is pretty superficial. No bends. Should I just sand down myself and diy or send to shop and if shop how $$$”source ↗
CedomanGamerYT · r/MechanicAdvice · 1 upvotes
Where this came up
People with this problem also raised
- 14Are new brake pads with a chipped corner safe to use?
- 4Can I reuse a damaged flywheel with grooves and hot spots?
- 4How do I remove unfamiliar aftermarket wheel locks and hardware?
- 3Why are there unexplained bumps on the inside of my wheel rim?
- 2Can you reuse brake caliper carrier bolts?
- 14How to tell if a worn timing belt actually needs replacing