How to route vanity plumbing to fit drawers
Standard plumbing lines often block drawer-only vanities when the water supply and drain do not enter from the same place. To maximize cabinet space and clear the sides of the vanity, you may need to lower the wall pass-through or reconfigure the pipe layout.
What people tried
Every workaround mentioned in the threads below. We haven’t tested any of them — and nobody here is claiming they worked.
- 1modify the cabinet
- 2notch the vanity
- 3rebuild it to raise it instead of lower it
- 4Avoiding drawers where the plumbing is located
In their words
Unedited, most upvoted first, each linked to the thread it came from.
“What is the best way to route this drain? I need to lower the pass through in the wall by ~2 inches in order to clear the side of the vanity.”source ↗
“I would like my new cabinet to have drawers only and wondering what the best way to configure the plumbing is to maximize the cabinet/drawer space?”source ↗
“Dont plan on having drawers where the plumbing is. Water and drain not coming from the same place makes things tough.”source ↗
Where this came up
People with this problem also raised
- 3Why does the drain snake keep coming out the other drain?
- 5Does every sink need a P-trap?
- 2How to install a vanity over floor pipes in a tight space
- 2Double vanity plumbing slope and drainage issues
- 9How to fix an off-center toilet drain during a remodel
- 4Where do I run the vent for a washer installation?