What people keep running into with dryer maintenance
Complaints tagged dryer maintenance, each raised by more than one person. One-off posts are not included.
9 recurring problems · 77 people · 9 forums we read
Raised more than once
Most people first.
- 21Why is my new dryer vibrating and buzzing?Dryers can develop persistent vibrations and buzzing sounds shortly after purchase due to internal debris build-up. This loud mechanical noise can make the appliance intrusive to run and prompt users to question whether the issue stems from a defect or general maintenance.
- 13Washing machine leaking from the door seal even after replacing gasketA damaged or improperly seated rubber boot seal causes water to leak around the washing machine door. If replacing the gasket fails to stop the leak, the tub alignment, door latch, or spring clamp tension may be off, preventing a proper watertight seal during cycles.
- 12Why does my clothes dryer sound like a loud vacuum?A loud vacuum-like noise during operation is usually caused by a failing idler pulley or drum support wheel. This racket makes the appliance disruptive to run and leaves you guessing whether a part is about to fail completely.
- 8Dryer won't start after a loud bangA loud bang and a dead dryer usually indicate a blown thermal fuse or a tripped breaker caused by an internal component failure. This prevents the machine from powering on or turning, leaving users stuck trying to locate and test hidden parts like fuses without a bank login or prior repair experience.
- 6Gas dryer runs and tumbles but stops heating after a few minutesGas dryers often start out heating normally before the flame cuts out and the air goes cold while the drum keeps tumbling. This leaves clothes damp or completely wet even after running for a very long time.
- 6How to get melted plastic off a car exhaust pipeDriving with melted plastic on an exhaust pipe is generally safe once the bulk of it is scraped off, though it will produce a strong burning smell until the remainder burns away. Alternatively, the pipe can be heated up to soften the residue for easier peeling, or cleaned with specialized products like oven cleaner once cooled.
- 5Why does my dryer keep blowing new thermal fuses?Replacing a dryer heating assembly or thermal fuse often fails to solve the issue when the new fuse burns out again after just a couple of loads. This leaves owners with a dryer that tumbles without heat and no clear direction on what underlying component to check next.
- 4Dryer runs full cycle and spins fine but clothes stay wetThe clothes stay wet and cold because the dryer's heating system fails to warm the air despite a strong exterior vent airflow and normal drum rotation. This leaves users with full loads of damp laundry after a complete cycle, requiring them to repeatedly run the machine or air-dry clothes by hand.
- 2Why does my dryer heating element connector keep burning out?A melted terminal on a heating element or thermal cutoff usually indicates a loose or high-resistance connection that creates excessive heat and current draw. Simply replacing the burnt part or sensors without fixing the underlying connection issue will cause the new connector to melt again.
Comes up alongside
Topics that keep appearing on the same problems — not topics with similar names.